Making Detailed Settings On Measurement Devices For Internal Measurement Modules Of The Sma Fuel Save Controller - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

SMA Solar Technology AG
Requirement:
☐ You must be logged in as Installer.
Procedure:
1. Select the menu Configuration Wizard via the page and menu selection.
2. In the Measurement System bar, select the [Adjust] button.
3. To configure measurement devices that are connected via the internal measurement modules of the
SMA Fuel Save Controller, perform the following steps:
• In the menu Measurement devices general configuration, set the parameters in the area Internal
measurement devices (see SMA Fuel Save Controller user manual).
• Select the [Continue wizard] button. Doing so calls up the detailed system settings (see Section 7.5.2,
page 57).
4. To configure measurement devices that are connected via a Data Acquisition Module, perform the following
steps:
• In the menu Measurement devices general configuration, set the parameters in the area External
measurement devices (see SMA Fuel Save Controller user manual).
• Select the [Continue wizard] button. Doing so calls up the detailed system settings (see Section 7.5.3,
page 59).
7.5.2 Making Detailed Settings on Measurement Devices for Internal
Measurement Modules of the SMA Fuel Save Controller
The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode. The operating state STANDBY can be reached by stopping the SMA Fuel Save Controller.
Measurement devices detailed configuration
Figure 22: Detailed system settings for measurement devices that are connected via the internal measurement modules of the
SMA Fuel Save Controller (example)
User Manual
7 System Settings
FSC20-BA-xx-20 57