Activating/Deactivating Devices - SMA FUEL SAVE CONTROLLER 2.0 Instrucciones De Uso

SMA Solar Technology AG
Procedure:
1. Set the desired parameters in the menu Measurement devices general configurations (see
SMA Fuel Save Controller user manual).
2. Ensure that the devices connected to the digital inputs of the Data Acquisition Module are correctly configured in
the SMA Fuel Save Controller. To do so, select the button [Show devices] and compare the devices connected
to the Data Acquisition Module with the devices configured on the Fuel Save Controller.
Example: Configuration of the digital inputs of the Data Acquisition Module on the
SMA Fuel Save Controller
If the genset 1 is connected to digital input DI 1 on the Data Acquisition Module and the utility grid is connected
to digital input DI 2, then the settings on the SMA Fuel Save Controller are correct in this example.
If the utility grid is connected to digital input DI 1 on the Data Acquisition Module and the genset 1 is connected
to digital input DI 2, then the settings on the SMA Fuel Save Controller are incorrect in this example. Incorrectly
configured devices must be deactivated and reactivated with the correct settings.
3. To activate or deactivate devices for the selected measurement device, select the button [Show devices] in the
Assign measurement points bar 61.
4. To continue with system settings, select the [Continue wizard] button.
5. Select the [Done] button.
6. End the system settings (see Section 7.9.1, page 67).
7.5.4

Activating/Deactivating Devices

The system settings of the Fuel Save Controller can only be adjusted when the Fuel Save Controller is in STANDBY or
ERROR mode. The operating state STANDBY can be reached by stopping the SMA Fuel Save Controller.
Requirement:
☐ You must be logged in as Installer.
User Manual
7 System Settings
FSC20-BA-xx-20 61