JUKI DDL-9000A Manual De Instrucciones página 10

cAutIon BEForE oPErAtIon
WArnInG :
To avoid malfunction and damage of the machine, confirm the following.
• remove the air-vent cap (red color) attached to the sewing machine bed.
• Clean the sewing machine thoroughly before using it for the first time.
• remove all dust collected on the sewing machine during the transportation.
• Confirm that the voltage and phase are correct.
• Confirm that the power plug is properly connected.
• never use the sewing machine in the state where the voltage type is different from the
designated one.
• the direction of rotation of the sewing machine is counterclockwise as observed from the
handwheel side. Be careful not to rotate it in reverse direction.
• Do not tilt the machine head toward this side since oil leakage or parts breakage occurs.
• A safety switch is installed so that the sewing machine cannot be operated with the machine
head tilted.
• When operating the sewing machine, turn on the power switch after properly setting the head
on the table.
• Before starting a test run, remove the bobbin case and the needle thread from the machine.
• operate the handwheel after the sewing machine has totally stopped.
ix