Transport; Packing; Unpacking - Silca Tri-Code Manual De Uso

Operating manual - English
2

TRANSPORT

The key-cutting machine is easily transported and is not dangerous to handle.
The packed machine should be carried by at least two people.
2.1

PACKING

The packing for the TRI-CODE H.S. is designed to ensure safe transportation and protect the machine
and all its parts.
It comprises a pallet base (b) to which the machine is attached and a cardboard box as a cover (a).
The machine is fixed to the base with screwed down brackets that hold it firmly in place during transport,
avoiding damage to the protective shield.
The closed packing is held in place by two straps which hold the cardboard box firmly on the pallet.
Symbols are printed on the outside of the cardboard box to give instructions and warnings for
transportation.
Note: keep the packing and use it every time the machine must be transported.
Fig. 6
Keep dry
Attention: put the machine into its original packing and fix it with the brackets every time it is transported.
2.2 U
NPACKING
To remove the machine from the packing box:
1) cut the straps with scissors and remove
2) raise the top part of the cardboard box
3) loosen the screws on the front and rear brackets holding the machine on the pallet
4) use the special spanner to loosen the nuts on the machine feet by a couple of turns
5) remove the metal brackets and tighten the nuts on the feet.
6) check the contents of the box, comprising:
1 TRI-CODE H.S. key-cutting machine
1 set of documents, including: operating manual, spare parts list and guarantee
1 power cable
1 tool kit (with standard clamp)
a
Handle with care
Copyright Silca 2006
b
This side up Don't use
TRI-CODE H.S.
9