Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operating manual - English
7.17

WIN-TRANSFER

MACHINE PROGRAM
The machine is supplied with an internal program already loaded and tested in our workshops.
The user therefore does not need to carry out any operations.
Only in the situations described below can the WIN-TRANSFER program be used to re-start the
machine.
The following is a list of situations where the use of the WIN-TRANSFER. program is required
For further details on installation and use of the program, follow the instructions given on the
instruction sheet provided with CD ROM.
• Replacement of the electronic board (see Ch. 7.4, page 73) or loss of the internal machine
program
1) replace the board with a new one, if necessary.
2) install on your Personal Computer the latest version received of the WinTransfer program and follow
the instructions given on the instruction sheet provided with the program.
3) read the serial number on the data plate on the back of the machine (Ch. 5.8.1 "Machine data", page
57) and enter on the machine.
4) gauge the machine according to the instructions in the manual, as follows:
- gauge as explained in chapters 5.7.4 "Machine Zero Points" and 5.6 "Calibrations" in the Operating
manual.
At this point the machine is set and ready for operation.
• SILCA update for the program or machine data
1) install on your Personal Computer the latest version received of the Win-Transfer program and
follow the instructions given on the instructions sheet provided with the program.
PROGRAM FOR LOADING
Copyright Silca 2006
TRI-CODE H.S.
/
UPDATING THE INTERNAL
83

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para Silca Tri-Code

Tabla de contenido