Description Of Work Station; Graphics; Separate Parts - Silca Tri-Code Manual De Uso

Operating manual - English
3.4 D
ESCRIPTION OF WORK STATION
The machine needs only one operator, who has the following controls at his/her disposal (fig. 4, page 6):
• master switch placed on the back of the machine
• key positioning clamp
• keypad
• display
• emergency push button
3.5 G
RAPHICS
The Plexiglas protective shield carries an adhesive warning label (fig. 9).
This label must never be removed.
Fig. 9
3.6 S
EPARATE PARTS
The standard clamp (fig. 10) is in the tool kit and not installed on the machine.
Install as indicated in this operating manual (Ch. 4.4, page 18).
Attention: for the initial start-up DO NOT install the clamp UNTIL the axis clearing procedure has been carried
out.
Fig. 10
12
Do not use compressed air
for cleaning
Copyright Silca 2006
TRI-CODE H.S.