Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Operating manual - English
5.8.4
Clamp detection
Enter the number for the chosen clamp:
•
0 = the clamp detection procedure will not take place before the cutting or decoding cycle.
Attention: if the clamp is not positioned properly the tools may break.
•
1 = the clamp detection procedure will take place before each cutting or decoding cycle.
•
2 = the clamp detection procedure will take place before the cutting or decoding cycle only if the
clamp is in a position different form the one in use.
5.8.5
Worn cutters
Allows enabling or disabling of the Worn Cutter function (Ch. 5.7.1, page 47).
5.8.6
Language
Enter the number that corresponds to the language you intend to work with.
5.8.7
Clock (hidden menu)
This menu is used to set the values for Date and Time.
To gain access to the function press SHIFT+ [down arrow key].
1 - Place the cursor on 1 and press ENTER, the display will show:
Press the arrow keys [up/down] to change the sector to be edited, then use SHIFT + [arrow down] to
set the exact figure.
Press ENTER to confirm. Press STOP to exit.
2 - Place the cursor on 2 and press ENTER, the display will show:
Press the arrow keys [up/down] to change the sector to be edited, then use the arrow keys [left/right] to
set the exact figure.
Press ENTER to confirm. Press STOP to exit.
C l a m p d e t e c t i n g : 1
0 = D i s a b l e d
1 = A l w a y s e n a b l e d
2 = O n l y w h e n c h a n g i n g
C u t t e r w e a r = 1
( 0 = D i s a b l e d )
( 1 = E n a b l e d )
S e e o p e r a t i n g m a n u a l
S e l e c t l a n g u a g e = 1
1 : I t a l i a n o
2 : E n g l i s h
3 : D e u t s c h
4 : F r a n ç a i s
5 : E s p a ñ o l
1 - F o r m a t d a t e & t i m e
2 - S e t u p d a t e & t i m e
D A T E - T I M E
D a t e : D D / M M / Y Y
T i m e :
0 - 2 4
D A T E - T I M E S E T T I N G
D a t e : 2 1 / 0 4 / 0 6
D M Y
T i m e :
1 0 : 2 0 : 2 0
Copyright Silca 2006
TRI-CODE H.S.
59
Publicidad
Capítulos
Tabla de contenido
