Motor / Condenser Replacement - Silca Tri-Code Manual De Uso

Operating manual - English
7.14 M /
OTOR
1) Turn off the machine and unplug.
2) open the top compartment (Ch. 7.6, page 75).
3) turn the machine over onto its side.
4) open the rear compartment (Ch. 7.7, page 76).
5) open the bottom compartment (Ch. 7.8, page 76).
Condenser:
a) loosen the fixing nut (Z1) and remove the washer and condenser.
b) fit the new condenser and fix with the washer and nut.
c) remove the cap (Z2) on the new condenser.
d) remove the cap from the old condenser, detach the 2 connectors (a) and (b) paying careful atten-
tion to their position, and connect to the new condenser.
e) replace the cap (Z2) on the new condenser.
Motor:
f) cut the 4 nylon ties on the wiring.
g) press on the connector grips (Z3) to remove them (fig. 75).
h) remove the belt.
i) loosen the screw (Y1) and remove the pulley (fig. 76).
j) loosen the 4 screws (Y2) fixing the motor and remove (fig. 76).
k) Install the new motor by carrying out in reverse the operations described above. If necessary, also
replace the condenser.
6) close the bottom compartment.
7) close the rear compartment.
8) close the upper compartment.
Fig. 74
Z3
Fig. 75
CONDENSER REPLACEMENT
Z1
Copyright Silca 2006
Z2
a
b
TRI-CODE H.S.
Z1
81