Initial Operations - Silca Tri-Code Manual De Uso

Operating manual - English
HONDA
Keyblank profile, cutting =
Keyblank profile, cutting =
Keyblank profile, cutting =
Keyblank profile, cutting =
5.2 I
NITIAL OPERATIONS
When the key-cutting machine has been placed on its workbench and connected to the mains (Ch. 3,
page 11), proceed as follows:
1) make sure that the emergency button is off (P - fig. 4, page 6).
2) turn on the machine by means of the switch on the back (A - fig. 5, page 6).
3) to check or alter the parameters for use of the machine, consult menu Ch. 5.8 "Options - 5", page
57.
When the machine is turned on, for a few seconds the display shows the software version installed and
the machine model:
Version = this refers to the version of the internal software that runs the machine functions.
The value changes with every update.
Ver. DB = this refers to the version of the data relating to the Systems-Locks entered. Ask SILCA to
update your machine database with all the new systems available on the market.
The value changes with every
The WinTransfer program (see Ch. 5.10, page 67) allow updating of the program and machine data
with the aid of a PC and a serial connection.
The display shows (on initial start-up only):
Use the arrow keys [up and down] to position the pointer and choose an option by pressing [ENTER],
The display shows:
Press ENTER to confirm.
Side A
Axis 1
Side A
Axis 2
Side B
Axis 1
Side B
Axis 2
T R I - C O D E H . S .
V e r s i o n x . x . x x x
( v e r . D B x x . x x )
update.
S e l e c t l a n g u a g e . = 1
1 - I t a l i a n o 2 - E n g l i s h
3 - D e u t s c h 4 - F r a n c a i s
5 - E s p a n o l
S a v e t h e
m o d i f i c a t i o n ?
N o = S T O P Ye s = E N T E R
Copyright Silca 2006
TRI-CODE H.S.
21