Silca Tri-Code Manual De Uso página 46

Operating manual - English
As soon as it goes to ON, press ENTER, and the display will show:
Loosen the (O1) grub screw with the 2mm (0.0787") hex. wrench (fig. 34). Leave the hex wrench on the
grub screw (O1) hold the lower knurled dial still and turn the upper graduated bush to position 6 aligned
with the notch on the spindle support.
bush
dial
Fig. 35
Press ENTER; the display will show:
Lock the grub screw (O1) with the 2mm (0.0787") hex wrench.
Remove the hex wrench. Turn the two dials together to the left until they are on position 10 (you should
hear a click).
Lower the protective shield.
Press START; the display will show:
- Press STOP to keep the current values for cutter duration by returning to the previous menu.
- Press ENTER to clear the current cutter duration values (preferably when replacing a worn cutter
with a new one).
U n l o c k g r u b s c r e w
r e g u l a t e n u m b e r e d
r i n g t o p o s i t i o n 6
[ E N T E R ]
L o c k g r u b s c r e w
a n d r o t a t e d i a l
t o p o s i t i o n 1 0
[ E N T E R ]
Z e r o o u t
c u t t e r l i f e ?
N o = S T O P Ye s = E N T E R
Copyright Silca 2006
TRI-CODE H.S.
O1
41