Silca Tri-Code Manual De Uso página 59

Operating manual - English
- press ENTER; the display will show the message:
Move the upper X and lower Y carriages by hand so that the U111 tracer point is in contact with both
the sides of the Z21 template (fig. 50).
Lower the safety shield and press START. First the display will show the message:
then:
Attention: if the tracer point and template are not in the position shown in fig. 50 the following message appears
on the display:
Check that the template Z21 and the U111 tracer point are positioned as shown in fig. 50.
Press [ENTER] and carry out the procedure described above.
54
B r i n g t r a c e r i n
c o n t a c t w i t h Z 2 1 .
S e e o p e r a t i n g m a n u a l .
[ S T A R T ]
P o s i t i o n i n g
i n p r o g r e s s !
S e n s o r p o s i t i o n i n g
I C X = O F F I C X = O F F
S e e o p e r a t i n g m a n u a l .
[ S T A R T ]
T E M P L A T E E R R O R
N o c o n t a c t m a d e .
S e e o p e r a t i n g m a n u a l .
Copyright Silca 2006
TRI-CODE H.S.