Cutting Test - Silca Tri-Code Manual De Uso

Operating manual - English
5.7.3

Cutting Test

Select the function from the main menu by placing the cursor on "4 - Maintenance"
Select "3 - Cutting Test".
Install the key (HON66 type) or one with the following dimensions:
Place the key into the clamp, as shown in fig. 44.
Fig. 44
Press START
At the end remove the key/template (fig. 45) and check the obtained measurements with a gauge.
If the dimensions do not correspond it's necessary repeat the calibrations (Ch. 5.6, page 34).
1 - C u t t e r s
2 - T e s t
3 - C u t t i n g T e s t
C L A M P A
C u t t . : H 1 0 1
P o s . : 2
6,2mm (0.2439")
.
C u t t i n g
i n p r o g r e s s !
15 mm +/-0,05 (0.59" +/- 0.0019")
Copyright Silca 2006
D i a l : 5
[ S T A R T ]
2,2mm (0.0865")
1,95mm +/-0,05
(0.0767" +/- 0.0019")
6 mm +/-0,05
(0.236" +/- 0.0019")
TRI-CODE H.S.
Fig. 45
51