Cutter; Hanging The Cutter And Or The Tracer Point - Silca Tri-Code Manual De Uso

Operating manual - English
4.5 C
UTTER
The cutter provided is the "H101" that is suitable for cutting laser (sidewinder) type
Attention: the cutter to be used is shown on the display.
The type of cutter to fit is identified with the letter H (HSS) or W (hard metal).
4.6 C
HANGING THE CUTTER AND
To remove the tracer point U111 or the cutter H101 from the spindle, proceed as follows:
- raise the protective shield.
- turn the cutter spindle (by hand) in order to reach the tool-locking grub screw (E1) (fig. 27).
- with one hand hold the cutter or the tracer point that needs to be removed and with the other use a
2,5mm (0.0983") hex wrench to loosen the (E1) grub screw.
- remove the tool (cutter or tracer point).
To install cutter or tracer point, proceed as follows:
- raise the protective shield.
- insert the tool all the way up into the spindle.
- holding the tool with one hand, use the other to tighten the (E1) grub screw with the 2.5mm (0.0983")
hex wrench.
tracer point U111
Fig. 26
E1
tracer point
U111
Fig. 27
/
OR THE TRACER POINT
cutter H101
E1

cutter

H101
Copyright Silca 2006
TRI-CODE H.S.
keys.
decoder
U111DC
19