Hologic FLUENT FLT-100 Manual Del Operador página 11

Replacement accessories
In case any of the accessories fail during a procedure, replacement accessories should be kept within easy reach to be able to finish the
operation with the replacement components.
Cleaning the system
Do not sterilize the system.
Condensation / Water penetration
Protect the system from moisture. Do not use if moisture has penetrated the system.
System defect
If a system defect is suspected or confirmed, do not use the system. Ensure the system is fully functional as described in Chapter 8:
Maintenance.
Replacing fuse
Replace the fuse only with a fuse of the same type and rating. The fuse type is T5AH, 250 V fuses. There are 2 per system.
Single Use
Tubing sets are single use disposables.
Danger: Explosion Hazard
Do not use in the presence of an oxygen rich environment. Oxygen Rich Environment is environment in which the concentration of oxygen is:
a) greater than 25 % for ambient pressures up to 110 kPa; or b) the partial pressure of oxygen is greater than 27,5 kPa at ambient pressures
exceeding 110 kPa
Caution!
Electrical Interference:
• Electrical interference with other devices or instruments was practically eliminated when developing this system and none was detected
during testing. However, if you still detect or suspect such interference, please follow these suggestions:
- Move the Fluent Fluid Management System, the other device, or both devices to a different location
- Increase the distance between devices used
- Consult an electro-medical expert
• Do not sterilize or immerse the Fluent Fluid Management System in disinfectant.
• Electrical safety testing should be performed by a biomedical engineer or other qualified person.
• This equipment contains electronic printed circuit assemblies. At the end of the useful life of the equipment, it should be disposed of in
accordance with any applicable national or institutional related policy relating to obsolete electronic equipment.
Electromagnetic Safety
This section contains important information regarding the electromagnetic safety of this product.
• The Fluent Fluid Management System needs special precautions regarding electromagnetic safety and needs to be installed and put into
service according to the electromagnetic safety information provided in this manual.
• This equipment is designed and tested to minimize interference with other electrical equipment. However, if interference occurs with other
equipment it may be corrected by one or more of the following measures:
- Reorient or relocate this equipment, the other equipment, or both.
- Increase the separation between the pieces of equipment.
- Connect the pieces of equipment into different outlets or circuits.
- Consult a biomedical engineer.
• All equipment performance is considered safety-related performance. That is, the failure or degradation of the performance specified in this
manual will pose a safety risk to the patient or operator of this equipment.
Note:
If the Fluent Fluid Management System is put into service in accordance to the safety instruction in this manual, the product should remain safe
and provide the performance listed above. If the product fails to provide this level of performance, the procedure should be aborted. Contact
Hologic. The problem needs to be corrected before continuing or starting a new procedure.
English
Fluent Fluid Management System
Introduction
9