Device Protection; Finishing The Setup Process; Web Application; Opening The Web Application Via The Hotspot - Porsche Mobile Charger Connect Manual De Instrucciones

Web Application

Device Protection

US
To prevent an unauthorized vehicle from being
connected to the charger, a PIN prompt can be
configured.
FC
1. To activate the PIN prompt, select O
2. Enter a 4-digit PIN and confirm.
ESM
3. Enter the PIN again and confirm it.
Activation of the PIN prompt is confirmed.
PTB

Finishing the Setup Process

e Check the settings you entered using S
TR
and complete the installation.
RU
Web Application
Further configuration options and detailed
UK
information about the previous charging processes
can be displayed using a web application, which is
VIE specific to each charger.
Information
HE
– Depending on which browser you are using,
the web application will not open immediately,
but information about the browser's security
AR
settings will be displayed first.
– Whether or not you will need to enter the network
JPN
key for calling up the web application depends on
the device's operating system.
KOR
Opening the Web Application
via the Hotspot
CHS
The web application can be called up using a device
(PC, tablet or smartphone) via a hotspot set up by the
charger.
CHT
To set up a hotspot:
f Please see chapter "Hotspot" on page 11.
THA
12
e To call up the web application while a hotspot is
active, enter the following IP address in the
browser's address line: 192.168.0.1
Opening the Web Application
.
N
via WiFi
The web application can be called up in the browser
on a device (PC, tablet or smartphone) that is logged
into the same home network as the charger.
e Enter the current IP address of the charger in the
browser's address line. You will find the current IP
UMMARY
address under S
N
ETWORK INFORMATION
– or –
e Enter the host name of the charger in the
browser's address line. You will find the host
name in the letter containing access data.

Charging

Vehicle Charge Port

For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
for the charging and connection status at the vehicle
charge port:
f See Owner's Manual.
> N >
ETTINGS ETWORK
.
Electric shock, fire
DANGER
Risk of serious or fatal injury due to fire or electric
shock.
e Always observe the specified sequence for the
charging process.
e Do not disconnect the vehicle cable from the
vehicle charge port during the charging process.
e End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
e Do not disconnect the charger from the electrical
socket during the charging process.
Errors are shown on the display and are indicated by
red status LEDs. The error message, the cause and a
remedial measure will be displayed.
f Please see chapter "Malfunctions" on page 13.

Starting Charging

1. Insert the plug into the electrical socket.
Power button lights up white.
Status LEDs light up white.
The display switches on.
2. Insert the vehicle plug in the vehicle charge port.
Power button lights up white.
Status LEDs pulsate white.
For information on connecting the vehicle cable
to the vehicle charge port:
f See Owner's Manual.
Following a successful self-test and when the
connection is established, the status LEDs light
up white.
3. Charging starts automatically.
Power button lights up white.
Status LEDs pulsate green.