NAMCO PAC-MAN BALL Manual Del Usuario página 108

9. Remove 2off pozi head screws (M5x10) and remove the Pusher Table and
Pusher Guide Bracket.
10. Pull out the Pusher Guide Bracket from the Pusher Table.
11. Remove 2off countersunk washer nuts (M4), detach the bearing supports,
and remove the Flange Bushings.
Pozi head screw (M5 x 10)
Pusher table
Pusher guide bracket
12. Re-assemble in reverse order.
Panel Assy
Field Assy
• When re-assembling make sure that the gap, (approx 1mm), between
the Panel Assy and Field Assy is the same on the right and left sides
before tightening the screws.
•
When re-assembling, apply a lithium based grease to the pusher shaft.
• When re-assembling, adjust the gap, (approx 1mm), between the
pusher table and pillar stages (L), (R) to be the same on the right and
left sides, and ensure that coins do not fall in to the gaps.
Pusher guide bracket
Flange
bushings
Countersunk
washer nut (M4)
Bearing support
Approx. 1 mm
Page 108
Flange bushings
Countersunk
Pusher
washer nut (M4)
shaft
Bearing support
Countersunk
washer nut (M4)
Pusher table
Countersunk
washer nut
Flange
(M4)
bushings
Pusher table
Pillar stage (L)
Approx.
1 mm