NAMCO PAC-MAN BALL Manual Del Usuario página 114

5. Loosen the double point screw (M4x5), and remove the Wiper Motor Crank.
6. Remove the 4off pozi head screws(M3x6), with spring washers, and remove the
Wiper Motor.
7. Re-assemble in reverse order.
•
When re-assembling, make sure that the gap between the wiper motor
crank and the motor is 1mm before tightening the double point screw.
•
Make sure that the double point screw is in contact with the flat on the
motor shaft, and apply loctite to the threads before tightening.
Double-point screw
Motor
1 mm
Wiper motor crank
Double-point screw (M4 x 5)
Pozi head screws (with spring washers) (M3 x 6)
Page 114
Wiper motor crank
Wiper motor
Pozi head screws
(with spring washers)
(M3 x 6)