Hopper - NAMCO PAC-MAN BALL Manual Del Usuario

6-2-6-2

Hopper

1. Remove the Hopper Head and cover.
2. Turn the Motor Pulley to the left (counterclockwise) by hand.
During this process, lightly touch the Agitator Rod with a finger. If there is
excessive play between the base surface and scraper, the 2off grub screws
(M4x6) on the Wiper Boss may be loose. If they are loose, tighten them. If
this does not correct the excessive gap between the Base Surface and the
Scraper, contact your distributor.
Base surface
Scraper
(see 6-2-5 page 80)
Wiper boss
section
Agitator rod
Motor pulley
Page 86
Grub screws (M4 x 6)