Replacing The Checker Sensors - NAMCO PAC-MAN BALL Manual Del Usuario

7-4-3

Replacing the Checker Sensors

1. Remove the Checker Unit.
2. Remove the Checker Cover.
3. Disconnect the connector, remove the Checker Sensor by squeezing the
claws and remove the Sensor.
Red
Checker cover
4. Re-assemble in reverse order.
•
When re-assembling, make sure that the tongue is inserted in the slot
of the checker cover and that there is a gap of 4.5mm or more on the
inside of the tongue.
•
When re-assembling, face the shiny side of the checker filter toward
the front.
Checker cover
Checker sheet
Checker filter
5. After re-assembly, conduct a checker output test.
(see Motor Test page 61)
(see 7-4-2 page 110)
Connector
Blue
White
Checker base
Checker sensor
Checker base
Page 111
Checker filter
Checker sheet
Gap of 4.5 mm or more
on inside
Tongue