Replacing The Divider Solenoid Sensors - NAMCO PAC-MAN BALL Manual Del Usuario

7-7-4-2

Replacing the Divider Solenoid Sensors

The following describes the procedures for removing and re-installing the Coin
Selector (R) Assy. Follow the same procedures for the removal of Coin Selector
(L).
1. Remove the Coin Selector (R) Assy.
2. Disconnect the connector, remove 1off pozi head screw (M4x6), and
remove the Sensor Holder (R).
Sensor holder (R)
Pozi head screws (M4 x 6)
3. Remove 1off Phillips pan-head screw (M4x14), and replace the Solenoid
Sensor (R).
4. Re-assemble in reverse order.
Divider solenoid sensor (R)
Page 123
(see 7-7-1 page 119)
Connector
Phillips pan-head screw
(M4 x 14)