Replacing The Coin Sensors - NAMCO PAC-MAN BALL Manual Del Usuario

7-7-2

Replacing the Coin Sensors

The following describes the procedures for removing and re-installing the Coin
Selector (R) Assy. Follow the same procedures for the removal of Coin Selector
(L).
1. Remove the Coin Selector (R) Assy.
2. Disconnect the two connectors, remove 2off pozi head screws (M4x14),
and remove the twin-sensor holder.
• The coin sensor connectors are colour-coded in red and white. When re -
assembling, ensure that the connectors are matched colour to colour.
Coin outlet side
Pozi head screws (M4 x 14)
3. Remove 2off phillips pan head screws (M4x14) and replace the Coin
Sensors.
Coin sensors
4. Re-assemble in reverse order.
(see7-7-1 page 119)
Connector (white)
Connector (red)
Phillips pan-head screws
(M4 x 14)
Page 120
Twin-sensor holder
Coin slot side