Supplying Engine Lube Oil - Yanmar 4HLA-HTP Manual Del Usuario

4LHA-HTP/-HTZP
●
① Open the cock on the fuel oil inlet pipe line.
②Loosen the air bleeding screw on the fuel filter
by turning 2~3 times to the counter-clockwise
using a screw driver.
③Feed the fuel with the priming pump.
The priming pump is on the top of the fuel
filter.
Move the priming pump knob up and down
until fuel mixed with air bubbles flows out of
the air bleeding port.
④When the fuel coming out is clear and not mixed
with any bubbles, tighten the air bleeding
screw.

3.3 Supplying Engine Lube Oil

Fill with the specified amount of engine oil.
①Remove the filler cap on the top of the bonnet
and fill with oil.
②Remove the oil dipstick and supply lube oil to
the upper limit on the oil dipstick. To check the
oil level, insert the dipstick in fully.
Engine oil capacity : ALL: 13
③Reinstall the dipstick and tighten the filler cap
firmly by hand.
Oil pan : 10
_
27
[NOTICE]
Do not overfill.
Overfilling will cause oil to be sprayed
out from the breather during operation
and into the suction inlet, and lead to
engine problems.
_
Air bleeding
screw
Lube oil filler cap
Dipstick