Switching Off The Pc - Nussbaum WA 950 Instrucciones De Uso

In set-up you can choose between a standard job record (fast)
Standard job record
or a more detailed (Full).
Standard job record detailed
- Order: your personal order number
- Reg. N.: registration number of the car, you also can click the
drop down button to see, if this car has been already there. If
yes click . Is it a new car you can create a new vehicle record
Therefore you have to enter further information. When you
entered the data, click
- Customer: same as new car, either choose an existing custo-
mer of create a new customer.
- Operator: (person who did the alignment) Either choose
existing operator or create new operator.
- Code, Make, Description: are taken from the vehicle data
base.
- Mileage: enter the mileage of the vehicle
- Working notes: Here you can enter any additional information
for the customer.
- Vehicle: Additional information e.g. chassisnumber
74
1312 9989
1312 9991
and to save.
If a Roc (run-out-compensation) has not been made, a
note automatically will appear. This note can not be
deleted and will be printed on the report.
When you entered all data you come back to the print screen.
If you want to save the data to your local database, do
not forget to save job
print screen.
Print Job Record: In set-up you can choose, what kind
of job record shall be printed always.
You want to print more than what has been chosen in
set-up. Choose the report which shall be printed addi-
tionally:
Vehicle situation
Chassis situation
ports will be printed when clicking on the print screen.
End of Session after the job is saved. You get back to
main screen and to start with the next procedure.
6.

Switching off the PC

At the end of the measurement, immediately set the switches at
the wireless sensors (only WA 920 / 020) to 'OFF'. Put the
sensors at the corresponding parking position on the device
trolley and in the case of the wireless sensors, ensure that the
charging contacts are in contact with the corresponding points on
the sensor housing. In the case of wireless sensors (WA 920 /
020), do not switch off the machine with the main switch (red/
yellow), as long as the sensors are to be charged, but only shut
down the PC .
If you switch off the main switch of the equipment (only
in case of WA 920 / 020), the batteries of the sensors
do not get charged!
If the machine is switched off with main switch (only WA
920 / 020) the sensors will not be charged!
Are the sensors not switched off the sensors will also
not be charged!
when you are back on the
On the right bottom of the page a
pictogram will show, which re-
19.03.2010 1 689 979 873N