Original Mercedes-Process - Nussbaum WA 950 Instrucciones De Uso

Finally you recieve a data summary, in which both the target data
and the recorded measuring values, that means previous and final
values, are listed.
Data sheet with pervious and final values
By pushing the button
about the customer, the car or the process. These information are
shown afterwards as headline of the data sheet.
In the menu bar of the data sheet screen you can choose between
further possibilities: Either you can print the data sheet
you save it or you combine both possibilities
Both the recording of the final values and the end of the session
are further possibilities for your procedure.
11.2

Original Mercedes-Process

Requirement for the Mercedes- Process is an upgrade with the
smartcard 1 987 009 AS3N. Aditionally you need some special
accessoires.
1 689 979 873N 19.03.2010
you can fill in different information
11.2.1 Special accessoires for the Mercedes- Process
In order to accomplish the Mercedes- Process either a set of
Mercedes clamp holders or a set of 4- hole or 5- hole adapters is
required.
Set of Mercedes clamp holder- 1 987 009 A47N
Set of 5-hole adapters-
1 987 009 A04N
or
Furthermore the Mercedes toe pressure bar is required. The
utilization of a toe pressure bar minimizes the effects of the
.
bearing clearence of the front axle during process of measuring.
Mercedes toe pressure bar- 1 987 009 A01N
Set of 4-hole adapters
1 987 009 A05N
87