Freestyle Libre 2 Manual Del Usuario página 101

Use the Reader's built-in meter within the test strip operating temperature
range (59 °F – 104 °F) or you will see Error Message E-1.
Use a test strip immediately after removing from its foil packet.
Only use a test strip once.
Do not put urine on the test strip.
Do not use expired test strips as they may cause inaccurate results.
Do not use at altitudes higher than 10,000 feet above sea level.
Do not use a wet, bent, scratched, or damaged test strip.
Do not use the test strip if the foil packet has a hole or is torn.
Results from the built-in meter are shown only in your Logbook and not in
other history options.
Refer to your lancing device instructions for use for how to use your lancing
device.
This device is not intended for use with multiple patients in health care or
assisted-use settings such as hospitals, physician o"ces, or long-term care
facilities because it has not been cleared by FDA for use in these settings,
including for routine assisted testing or as part of glycemic control
procedures. Use of this device on multiple patients may lead to transmission
of Human Immunodeficiency Virus (HIV), Hepatitis C Virus (HCV), Hepatitis B
Virus (HBV), or other bloodborne pathogens.
Blood Glucose Testing
You can use the built-in meter to check your blood glucose, whether you are
wearing a Sensor or not. Be sure to read the test strip instructions for use prior
to using the built-in meter.
CAUTION: Test on your fingers in accordance with the Intended Use in this
section.
1. Wash your hands with warm soapy water for accurate results. Thoroughly dry
your hands. To warm the site, apply a warm dry pad or rub vigorously for a
few seconds.
ART46983-001_rev-A 24-Aug-2022 2:30pm