Attachment; Intended Use - salmson SIE BV Serie Instalacion Y Puesta En Servicio

3.2

Attachment

Fig. 15: Attaching the pump
Fig. 16: Attaching the motor
4

Intended use

Purpose
Fields of application
Contraindications
Installation and operating instructions SIE...BV/DIE...BV/PBE...BV
WARNING! Risk of personal injury!
Improper transport can lead to personal injury.
• The pump must be transported using approved load bearing equip-
ment. This is to be attached to the pump flanges and, if necessary,
to the outer motor diameter (safety device to protect against slip-
ping required!).
• To lift with a crane, the pump must be supported by suitable belts,
as shown. Place loops around the pump which tighten from the
pump's own weight.
• The transport eyes on the motor are only for guiding as the load is
carried (Fig. 15).
• The transport eyes on the motor are only for transporting the
motor, and are not approved for transporting the complete pump
(Fig. 16).
The glanded pumps in inline design of the SIE...BV, DIE...BV and
PBE...BV series are used as circulation pumps in building services for
the following:
• Hot water heating systems
• Cooling and cold water circulation systems
• Industrial circulation systems
• Heat carrier circuits
CAUTION! Risk of damage to your health!
The pumps may not be used for potable water applications!
• The correct use of the pump/installation also includes following
these instructions.
• Any other use is considered to be incorrect use.
English
33