Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Starting
In the off state, a long press of the button
for 2 seconds will start the device and display the boot status
as shown below:
Unit shutdown state
Launch status - manual operation mode
Launch status - automatic operating mode
Switching off
In idle status, press and hold the
button for 2 seconds, the unit enters the blowing and cooling process
and
is displayed. After cooling down, the device will turn off.
During this time, do not force the device to turn off in the cooling process. Direct power failure can damage
parts because the unit temperature is too high to dissipate heat. The power can only be cut off when the
unit is turned off.
Manual mode
Manual mode has six gears (H1-H6) (or eight gears H1-H8 depending on the model). The H6 / H8 represents
the maximum power as shown above. In the starting state, the level can be changed by adding or subtracting
gears via the "up" / "down" buttons.
Automatic operating mode
The figure above shows the 20°C setting. The temperature value can be changed with the setting buttons
"up" / "down". Switching between manual and automatic modes: long press on the setting button
.
Publicidad
