MSW Motor Technics MSW-DPH-01 Manual De Instrucciones página 36

EN
The fuel filter should be installed upstream of the fuel inlet port. Make sure the fuel flow is correct. Its position
should be as shown in the figure above.
Installation of the fuel line
Use only steel and plastic hoses made of light- and heat-resistant plastic in accordance with the requirements
of DIN 73378 as fuel lines. The inner diameter of the cable is 2 mm.
The fuel line should be located away from flying stones and parts of the vehicle that emit heat. If necessary,
the protective device can be locked.
The fuel line from the fuel pump to the primary heater should be oriented in any direction other than
downward. The fuel line should be tied in a suitable place to keep it stationary. The distance between the
two ties should be less than 50 cm.
The fuel line fittings supplied with the heater should be used for the connections between the fuel line and
the fuel pump, the fuel line and the heater, the fuel line and the suction line of the fuel tank, and the fuel line
and reducer. The fuel line should be tied with the fuel line clamps. Air bubbles should be removed from the
connection points.
1 - Clamp for fuel line
2 - Fuel line
3 - Connection piece
Installation of the fuel extraction device
The holes in the fuel tank (or tank cap) for installation should be of the correct size, with trimmed edges, and
evenly spaced around the hole. The lower end of the fuel line should be 30-40 mm from the bottom of the
fuel tank to suck in enough fuel and at the same time to avoid sucking in dirt deposited on the bottom of the
fuel tank.