MSW Motor Technics MSW-DPH-01 Manual De Instrucciones página 33

EN
WARNING
The emission of exhaust gases
Poisoning and suffocation
Make sure that the housing adheres only to the base of the unit after installation.
Make sure the housing gasket is properly installed.
Make sure that the exhaust gases are discharged only to the outside of the vehicle.
The support surface of the base of the unit must be flat.
Installation of the device - applies to MSW-DPH-01 / MSW-DPH-03
Make sure that the place of installation meets all requirements.
Ensure the correct installation position.
The vehicle manufacturer's requirements must be met.
For unevenness> 1 mm: level the backrest surface.
Make holes using a metal hole pattern.
Install the base gasket between the heater and the contact surface.
Fasten the heater to the base with the nuts.
Make sure that the heater rests on the base.
Device base gasket
Cold and hot air system
The cold and hot air system of the heater must not be combined with externally controlled ventilation
systems (e.g. vehicle air conditioning).
Recirculated and recirculated air mode: