Husqvarna TE 310 I.E. 2010 Manual De Uso Y Mantenimiento página 115

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

ENGINE START (TE-SMR)
With cold engine, as after a prolonged inactivity of the motor-
cycle or in presence of a low external temperature, proceed as
follows:
1) set ignition key (1) in IGNITION position (the buzz that you
hear when you turn the key to IGNITION is caused by the
fuel pump which puts the feeding system under pressure);
2) pull the starter knob (2);
1
TE-SMR
3) pull the clutch lever (3);
4) shift gear pedal (4) in neutral position then release the
clutch control lever;
5) press the engine start-stop switch (5) then the start button
(6). Put the starter knob (2) in its initial position as soon as
the engine is idling. When starting with an already
warmed up engine DO NOT USE the starter. When a cold
engine has just been started, do not increase revs, to en-
sure an adequate oil warm-up and circulation.
2
TE-SMR
NOTE
A safety switch is set on the clutch lever support. This switch al-
lows you ONLY to start the engine with idle gearbox, or with
the gear engaged and the clutch lever pulled.
IMPORTANT
NEVER START WITH DISCONNECTED BATTERY.
3
5
4
TE-SMR
6
21

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido