Husqvarna TE 310 I.E. 2010 Manual De Uso Y Mantenimiento página 157

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

- Remove fluid reservoir cap (2), the rubber and fill the reser-
voir with fresh brake fluid.
- Open the bleeding valve and pump with brake lever (3) sev-
eral times until the fluid, clear and without bubbles, comes
out of the hose: now close the bleeding valve.-
- Restore the brake fluid level (A) then reassemble the rubber
and the fluid reservoir cap (2).
WARNING!
During the bleed operation the fluid level
inside the reservoir must never be lower
than the minimum level.
Tightening torque for bleed valve is 1,2 ÷
1,6 kgm (12 ÷ 16 Nm; 8.8 ÷ 11.8 ft-lb).
As the braking fluid is a very corro-
sive substance, in the case it comes
in contact with your eyes wash them
abundantly with water.
During the bleeding of the braking
circuit keep the handlebar turned
leftwards. This is the way to lift the
pump tank and to make easier the bleeding
of the braking system.
If the lever stroke gets stretchy and
the braking action results as poor in
the case of falls during competitions,
or after repair work in shops, repeat the
bleeding operation described above.
As the bleeding operation does not
fully eliminate the air inside the cir-
cuit, the small quantity of air re-
maining inside will be eliminated after a
short time of use of the brake. In this case
however, the action of the lever will be
harder and the stroke shorter.
63

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido