Husqvarna TE 310 I.E. 2010 Manual De Uso Y Mantenimiento página 138

ADJUSTING THE COMPRESSION FORK
(TC 450; TXC 450-510; TE 310-450-510)
a) Compression (TC,TXC: upper register; TE: Lower register)
Standard calibration: -7 clicks (TC-TXC);
Standard calibration: -10 clicks (TE);
Remove plug (B) and turn register (A) clockwise until the posi-
tion of fully closed is reached then, turn back by the men-
tioned clicks.To obtain a smoother braking action, turn the reg-
ister anticlockwise. Reverse the operation in order to obtain a
harder action.
a)
D
44
b) EXTENSION (TC-TXC: lower register; TE: upper register)
Standard calibration: - 10 clicks (TE).
Standard calibration: - 13 clicks (TC-TXC).
To reset standard calibration turn register (C) clockwise to
reach the position of fully closed; then, turn back by the men-
tioned clicks. To obtain a smoother braking action, turn the
register anticlockwise. Reverse the operation in order to obtain
a harder action.
b)
C
A
TC-TXC
c) AIR VENT (to carry out after each competition, or monthly).
Set the motorcycle on a central stand and release the fork fully
and loosen the air vent valve (D). Once this operation is over,
tighten the valve.
WARNING: Never force the adjusting screws
beyond the maximum opening and closure
positions.
TC-TXC