John Bean QUADRIGA 1000 Manual Del Operador página 72

1
NO
72
A
4.1-2
OK
5.1-3
Operations
WARNING: ONLY THE OPERATOR MAY ACCESS
THE WORK AREA.
WARNING: THE OPERATOR SHOULD STAND
CLOSE TO THE MACHINE IN THE CORRECT WORK
POSITION ON THE SAME SIDE AS THE CONTROL
PANEL.
• Move lever 1 (Fig. 4.1-2) on the Control Unit
forward to perform the automatic wheel lift procedure.
The machine beeps to warn that the procedure is
running and the operating tools move to the idle
position).
The load procedure ends when the wheel is resting
against the fl ange, the lifters have moved back to the
idle position and the beeper stops beeping.
5.1.1.2 Unloading the wheel
Unclamp the wheel as described in the relative chapter.
Remove the clamping cone
Move the shaft to the right down position.
Check that there is not already another wheel on the
front lifter (this would make the unloading procedure
impossible)
• Move lever 1 (Fig. 4.1-2) on the Control Unit
back to perform the automatic wheel unload procedure.
The tools move to the idle position and the Wheel
Support moves to the correct position.
The procedure ends when the lifter stops, having
practically reached the ground, and the beeper stops
beeping.
Figure 5.1-3
WARNING: REMOVE THE WHEEL FROM THE
LIFTER MANUALLY ON THE RIGHTHAND SIDE.
Operator's Manual QUADRIGA 1000/BB