Sun ECK TWIN 12 Manual De Instrucciones página 106

INSTRUCTIONS MANUAL
Locate the filling cap (ref 3, Fig.28) and screw it completely off.
3
The
FIG. 28
following screen is displayed:
VACUUM PUMP OIL CHANGE
DD/MM/YY XX:XX PM
Refill vacuum pump with new oil
To the center of the control glass
Then replace filling cap.
When done press ENTER to exit.
ENTER
The oil must be added through the hole in which the filling cap was lodged (ref 4, Fig.29)
FIG. 29
4
Add oil a little at a time, waiting for the level to rise before each successive addition, until the oil
level is about ½ cm above the red mark on the indicator (ref 1, Fig.26).
Replace the filling cap (ref 3, Fig.28) and tighten down.
Replace the rear plastic cover (ref 2, Fig.27)
-105-