Edit Vacuum Data; Edit Oil Data; Edit Uv Data; Edit Gas Charge Data - Sun ECK TWIN 12 Manual De Instrucciones

INSTRUCTIONS MANUAL
NOTE: press button to enable active box, then use the keypad to modify procedure
parameters

Edit VACUUM data

press VACUUM TIME button to enable active box, then use the keypad to modify vacuum
time.
NOTE: use the VACUUM SETTING to change the duration of the LEAK CHECK.
NOTE: if vacuum time is lower than 15 minutes the following popup warning will be displayed:
The selected vacuum time is
lower than 15 minutes.
The leaks check on A/C system will
be not reliable.
Continue?
YES NO
The leaks check will be not reliable, press YES to continue.

Edit OIL data

Press OIL* button to enable active box, then use the keys 0 to 9 to type the volume of oil to be
automatically reintegrated after Vacuum (type "0" for no oil injection), or select AUTO to
reintegrate the same quantity of oil extracted during Recovery.
* the OIL button could be disabled while servicing HYBRID VEHICLE, depending on OIL type

Edit UV data

Press UV* button to enable active box, then use the keys 0 to 9 to type the volume of UV to be
automatically reintegrated after Vacuum (type "0" for no UV injection)

Edit GAS CHARGE data

NOTE: For most systems the quantity of fluid to be refilled is indicated on a plate that is in the
vehicle's engine compartment. If this quantity is not known, look for it in the relevant manuals.
Press GAS CHARGE button to enable active box, then use the keys 0 to 9 to type the quantity
(in grams) of refrigerant to be charged into the A/C system.
Or, in installed, press DATABASE button, the following screen will be displayed:
Select the vehicle typology
-30-