Sun ECK TWIN 12 Manual De Instrucciones página 30

AUTOMATIC PROCEDURE
In the automatic mode, all the operations are performed automatically: recovery and recycling,
oil discharge, vacuum, new oil reintegration, and charging. The values for the quantity of gas
recovered, quantity of oil recovered, vacuum time, quantity of oil reintegrated, and quantity of
gas charged into the system are automatically printed at the end of each single operation.
Connect the hoses to the A/C system with the quick-connect couplings bearing in mind that
BLUE must be connected to the low-pressure side and RED to high pressure. If the A/C
system is equipped with a single quick-connect coupling for high or low pressure, connect only
the relative hose. Start the vehicle engine and switch on the air conditioner. Allow both to run
for about 5 to 10 minutes with the passenger compartment fan at full speed. Switch off the
vehicle engine.
From the MAIN MENU:
DD/MM/YY XX:XX PM
Select the AUTOMATIC PROCEDURE, the following screen is displayed:
NOTE: to change the type of OIL and UV refer to OIL SETTINGS (SETUP menu)
If HYBRID VEHICLE is selected the machine will perform FLUSHING HOSES
Select the STANDARD VEHICLE or HYBRID VEHICLE; the following screen will be displayed:
NOTE: When HYBRID VEHICLE is selected only
injection is allowed. PAG OIL, POE OIL and UV are disabled.
INSTRUCTIONS MANUAL
STANDARD VEHICLE HYBRID
VEHICLE
AUTOMATIC
0g
CHARGE AMOUNT
0ml
OIL
0ml
UV
2
VACUUM TIME
HP LP
-29-
DD/MM/YY XX:XX PM
ESC
DD/MM/YY XX:XX PM
ESC
AUTO
DATABASE
HP+L ENTE
R
P
UV HYBRID and POE HYBRID OIL