Easy Alu Functions - John Bean B 600 Manual Del Operador

1
62
5-18
Operation
5.6.3.2 Width Automatic Entry
The machines featuring a Sonar detector automatically
acquire the width while wheel protection moves down.
• Lower the protection with a regular and continuous
movement.
Important warning:
For machines without SONAR, width must be
always acquired through the keyboard.
Note: If more than one wheel of the same type need
to be balanced (with the same nominal dimensions) the
data must only be set for the fi rst wheel. The selections
stay set until other new data are set or the machine is
switched off.

5.7 Easy ALU Functions

ALU 2P & ALU 3P
The Easy Alu function allows to automatically obtain
the rim dimensional data:
By touching two separate points you can have both
ALU 2P e ALU 3Pmodes.
In both cases the Easy Alu Toggle (fi g. 5-18) key
allows to change the displayed selection after touching
the rim.
NORMAL & ALU 1P
By touching one point you have the NORMAL mode
available. The same applies by pressing Easy Alu
Toggle (fi g. 5-18) of the ALU 1P mode.
EASY ALU TOGGLE
Automatic correction of the proposed Alu
Depending on the gauge contact points on the rim,
the machine has interpreted a probable Alu mode
required by the user. Every time the Alu presented
by the machine does not correspond exactly to the
one required, it can be corrected using the "Easy Alu
Toggle" function.
— Press the "Easy Alu Toggle" key (Fig. 5-18) to
obtain an Alu mode alternative to that offered for
the rim being processed.
Note: The Alu can be changed only before the
measuring run.