John Bean B 600 Manual Del Operador página 92

26
92
5-60
5-61
5-62
5-63
Operation
Message E9
Message E9 means that at least one error has occurred
during the optimisation cycle (System messages
7.1).
— Press BALANCING or ESC key to quit the
optimisation program and, if desired, start a new
optimisation.
Figure 5-60 OPTIMISATION "OP.12"
(fourth measuring run with tyre)
— Clamp the wheel.
— Position the valve so that it is exactly perpendicular
to and above the chuck.
— Confi rm the valve position by pressing menu key
26.
The OPTIMISATION "OP.13" screen is displayed
5-61).
Figure 5-61 OPTIMISATION "OP.13"
START is displayed on the screen
— Perform the wheel measuring run.
A measuring run is performed.
The BALANCING screen appears (Fig. 5-62).
Finish weight Optimisation
Figure 5-62 BALANCING
— Balance the wheel according to the instructions
displayed.
If the wheel conditions cannot be improved, one of the
following messages is displayed
H0 Silent wheel running conditions cannot be
improved by optimisation.
H1 Further optimisation not recommended but feasible.
H2 Weight minimisation is recommended, optimisation
can achieve no further improvement.
F
(
Fig.
(
Fig. 5-63):