John Bean B340 Manual Do Operador página 102

26
29
102
5-70
5-71
5-72
5-73
5-74
Operation
Fig. 5-70 MINIMISATION "Un.10", outside
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre
outer side exactly above the chuck.
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.11" is displayed (Fig. 5-72).
Figure 5-71 MINIMISATION "Un.10", inside
If the tyre cannot be turned over on the rim (e.g.:
Asymmetrical and Directional),
press the menu key 29, then
—
Continue as shown on screen
—
MINIMISATION "Un.10" (Fig. 5-70).
If the tyre can be turned over on the rim;
— Rotate the wheel into marking position following the
arrows
— In this position make a double mark on the tyre, on
the inside of the wheel, exactly above the chuck.
— Turn the tyre over on the rim (tyre changer).
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.11" is displayed (Fig. 5-72).
Figure 5-72 MINIMISATION "Un.11"
— Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
— Confi rm by pressing menu key 26.
The MINIMISATION "Un.12" is displayed (Fig. 5-73).