Maintenance; Compensation Run - John Bean B340 Manual Do Operador

4
1b
26
108
7c
6-1
6-2
1
6-3

Maintenance

6.0 Maintenance

This unit is designed to operate for a long time.
If the operator shuts down the unit correctly (
at the end of each shift, no further maintenance is
required.
This unit must not be opened by the operator.
6.1

Compensation Run

All clamping and centring means are balanced within
a maximum permitted tolerance.
To compensate for any residual unbalance that might
be left in the clamping tool, it is recommended that a
compensation run be performed after switching on
the machine or after changing the wheel adaptor,
especially a motorcycle wheel adaptor. This mode
cannot be transferred into the permanent memory.
Application:
— Fit the clamping device properly on the balancer
shaft. Do not fi t the wheel.
— From the MAIN MENU select:
- SETTINGS (4).
COMPENSATION (7c, Fig. 6-1).
-
The COMPENSATION screen C4 (Figure 6-2) is
displayed.
— Start the compensation run using the START key
(1b).
The Compensation Run takes longer than a regular
measuring run. After the run, an icon in the Status Bar
indicates the Compensation Active status (1, Fig. 6-3).
Compensation remains active until cancelled by one
of the following cases:
- Selection of confi rmation with OFF key (26)
- after a recalibration,
- after an optimisation run or
- by switching off the machine.
5.4.4)
F