System Requirements; Initial Connection Between Cockpit App And Prosthesis; Starting The Cockpit App For The First Time - Ottobock C-Brace 17KO1 Serie Instrucciones De Uso

INFORMATION
The language of the Cockpit app user interface can only be changed by the O&P professional
using the adjustment app.
INFORMATION
The serial number of the component to be connected has to be registered with Ottobock the
first time it is connected. If the registration is not accepted, use of the Cockpit app for this com­
ponent will be limited.
INFORMATION
Bluetooth on the component must be turned on in order to use the Cockpit app. Briefly press
the button on the control panel to check. In the
If the symbol in the button is not lit up, Bluetooth has to be switched by a long press of the
button.

7.1 System Requirements

The functioning of the Cockpit app is assured on devices that support the following operating sys­
tems:
iOS (for iPhone, iPad, iPod): version 9.3 or higher. The mobile device has to support
•
Bluetooth 4.0 (BT LE).
Android: version 4.1 or higher
•

7.2 Initial connection between cockpit app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on (see Page 84).
• Bluetooth on the mobile device must be switched on.
• The device must not be in "flight mode" (offline mode), otherwise all wireless connections are
turned off.
The device must be connected to the internet.
•
• The serial number and Bluetooth PIN of the component being connected must be known.
They are found on the enclosed Bluetooth PIN card. The serial number begins with the letters
"SN".
INFORMATION
If the Bluetooth PIN card with the Bluetooth PIN and serial number of the component is lost,
contact your O&P professional.

7.2.1 Starting the cockpit app for the first time

1) Tap the symbol of the Cockpit app (
→ The end user license agreement (EULA) is displayed.
2) Accept the end user license agreement (EULA) by tapping the Accept button. If the end user
license agreement (EULA) is not accepted, the Cockpit app cannot be used.
→ The welcome screen appears.
3) Briefly press the
ility) of the Bluetooth connection for 2 minutes.
4) Tap the Add component button.
→ The Connection Wizard opens and guides you through the process of establishing a con­
nection.
5) Follow the subsequent instructions on the screen.
72
button on the control panel of the component to activate recognition (visib­
button, the symbol must be lit up blue .
).