Switching Bluetooth Of The Component On/Off; Switching Off Bluetooth; Switching On Bluetooth; Querying The Status Of The Component - Ottobock C-Brace 17KO1 Serie Instrucciones De Uso

8.6 Switching Bluetooth of the component on/off

INFORMATION
Bluetooth on the component must be turned on in order to use the Cockpit app. Briefly press
the button on the control panel to check. In the
If the symbol in the button is not lit up, Bluetooth has to be switched by a long press of the
button.

8.6.1 Switching off Bluetooth

► With the Bluetooth function activated, press and hold the
vibration signal is emitted and the symbol in the button turns off.
→ Bluetooth is switched off.
→ To check whether the Bluetooth function was deactivated correctly, query the status by press­
ing the button (see Page 92).

8.6.2 Switching on Bluetooth

► With the Bluetooth function deactivated, press and hold the
a short vibration signal is emitted and the symbol in the button lights up blue .
→ Bluetooth is switched on.
→ To check whether the Bluetooth function was activated correctly, query the status by pressing
the button (see Page 92).

8.7 Querying the status of the component

8.7.1 Query status through cockpit app

1) When the component is connected, tap the symbol in the main menu.
2) In the navigation menu, tap the entry "Status".

8.7.2 Status display in the cockpit app

Menu option
Steps per day: 25
Overall steps: 1745
Batt.: 68

8.8 Recommendations for air travel

Observing the following points is recommended prior to air travel or on board the airplane:
• Take along the 647F558 orthotic passport so you can show it on request or in case of ques­
tions.
• Turn off the component's Bluetooth function on board the aircraft if required (see Page 84).
• Take along the corresponding power supply adapter according to your destination. The
power supply is suitable for connecting to alternating voltages from 100 V to 240 V at a net­
work frequency of 50 Hz to 60 Hz.

9 MyModes

In addition to the MyModes "Training mode" and "Freeze position", the O&P professional can
configure a MyMode "User defined" using the adjustment app. These MyModes can be selected
using the Cockpit app.
84
Description
Daily step counter
Total steps since most recent
maintenance
Current charge level of the
component in percent
button, the symbol must be lit up blue .
button on the control panel until a
button on the control panel until
Possible actions
Reset the counter by tapping
the "Reset" button.
For informational purposes
only
For informational purposes
only