6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, 3 beep signals sound and the
appears in the bottom right corner of the screen.
The
symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This pro
cess may take up to a minute.
Then the main menu appears with the name of the connected component.
INFORMATION
After the initial connection to the component has been established successfully and when the
Bluetooth function is activated, the app will connect automatically each time it is started. No fur
ther steps are required.
INFORMATION
After activating the "visibility" of the component (briefly pressing the
can be recognised by another device (e.g. smartphone) within 2 minutes. If registration or
establishing the connection takes too long, the process of establishing a connection is can
celled. In this case the
INFORMATION
If the connection to the component could not be established or the connection process is ter
minated, reset the component by connecting and disconnecting the battery charger.
7.3 Control elements for cockpit app
1
Product
2
1. Basic Mode
2. Training mode
4
5
3. Freeze position
4. User defined
6
100%
1. Basic Mode
button on the control panel must be briefly pressed again.
1.
Access the navigation menu (see Page 74)
2. Name of the component. This name can only be changed
using the adjustment app.
change
3
3. If connections to more than one component have been
saved, you can switch between the saved components by
tapping the change item (see Page 74).
4. MyModes configured with the adjustment app.
Switching the mode by tapping the corresponding symbol
and confirming by tapping "OK".
5. Currently selected mode
6. Charge level of the component.
7
8
The current charge level is also displayed in %.
7. Display and name of the currently selected mode (e.g. 1.
Basic Mode)
8.
is attempting to re-establish the connection automatically.
No existing connection to the component.
Component battery fully charged
Component battery empty
Component battery is being charged
Connection to component has been established
Connection to component has been interrupted. The app
symbol
button), the component
73