Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento página 37

Record Stream
If you are recording your stream via USB-C on ATEM Mini Pro, this palette is where you can
control your disks and start and stop recording. You can also set a file name and trigger record
in all cameras when connected to Blackmagic Pocket Cinema Camera 4K and 6K.
NOTE When your ATEM Mini Pro's USB-C output is connected to an external disk for
recording and you want to keep using ATEM Software Control, you will need to
connect your ATEM Mini Pro to your computer via Ethernet.
Refer to the 'connecting to a network' section for more information.
File Name Prior to recording, set a file name by typing it into the file name window.
Click anywhere outside the window to confirm. If you stop and start recording,
the file name will assign version numbers incrementally.
Drives Formatted drives connected to your ATEM Mini Pro will appear as a list in the
record window. You can assign drives by selecting them from the drop down
menu. The drive window displays the disk capacity and record time remaining.
Recording will always begin with the disk containing the largest available space,
then proceed to the next disk with the largest available space. However, you can
manually switch the drive you are recording to by clicking the 'switch' button. This
is helpful if there is less than 5 minutes remaining on the current disk and you
want to switch it over to the next disk at a determined moment in your broadcast.
Switch Click the 'switch' button to change the drive you are currently recording to the
next drive with the largest available space.
TIP You can also switch drives by holding down the record button on ATEM Mini Pro.
ATEM Software Control 37