Tabla de contenido
Publicidad
15. Remove 2 nuts securing heater unit to crossmember.
15. Remove 2 nuts securing heater unit to crossmember.
16. Remove bolt securing heater unit to bulkhead.
16. Remove bolt securing heater unit to bulkhead.
17. Remove heater unit.
17. Remove heater unit.
Refit
1. Position heater to mountings.
1. Position heater to mountings.
2. Tighten all fixings to 10 Nm.
2. Tighten all fixings to 10 Nm.
3. Position intake duct and tighten nut to 10 Nm.
3. Position intake duct and tighten nut to 10 Nm.
HEATING & VENTILATION
4. Connect multiplug to heater blower.
4. Connect multiplug to heater blower.
5. Connect hoses to heater matrix and secure with
5. Connect hoses to heater matrix and secure with
clips.
6. Position valve and secure with screws.
6. Position valve and secure with screws.
7. Fit screen ducts.
7. Fit screen ducts.
8. Connect multiplugs to control unit.
8. Connect multiplugs to control unit.
9. Position control cables and connect to control unit.
9. Position control cables and connect to control unit.
10. Align cable outers to control unit and tighten clamp
10. Align cable outers to control unit and tighten clamp
screws.
11. Release clip securing cable outer to heater valve.
11. Release clip securing cable outer to heater valve.
12. Turn temperature control to COLD.
12. Turn temperature control to COLD.
13. Push heater control valve to the cold position and
13. Push heater control valve to the cold position and
secure cable clip.
14. Position alarm ECU to control unit, fit and tighten
14. Position alarm ECU to control unit, fit and tighten
nuts to 4 Nm.
15. Refill cooling system.
15. Refill cooling system.
+
DRAIN AND REFILL, page 26-1.
16. Fit fascia.
16. Fit fascia.
+
FASCIA PANEL, page 76-4-9.
80-11
REPAIRS
Publicidad
Tabla de contenido
