MG TF 2008 Manual De Servicio página 442

Tabla de contenido

Publicidad

AIR CONDITIONING
12. Replace receiver drier.
12. Replace receiver drier.
+
RECEIVER DRIER, page 82-5.
13. Remove stand(s) and lower vehicle.
13. Remove stand(s) and lower vehicle.
14. Connect battery earth lead.
14. Connect battery earth lead.
15. Recharge air conditioning system.
15. Recharge air conditioning system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
82-4
REPAIRS
CONDENSER
$% 82.15.07
Remove
1. Recover refrigerant from air conditioning system.
1. Recover refrigerant from air conditioning system.
+
REFRIGERANT RECOVERY, RECYCLING AND
RECHARGING, page 82-1.
2. Remove front bumper valance.
2. Remove front bumper valance.
+
BUMPER VALANCE - FRONT, page 76-2-9.
3. Remove 2 bolts securing top condenser mounting
3. Remove 2 bolts securing top condenser mounting
brackets to striker plate panel.
4. Remove brackets from condenser.
4. Remove brackets from condenser.
5. Remove 2 bolts securing air conditioning pipe
5. Remove 2 bolts securing air conditioning pipe
connections to condenser and release pipes.
6. Remove and discard 2 'O' rings from air conditioning
6. Remove and discard 2 'O' rings from air conditioning
pipes.
CAUTION: Immediately cap all air conditioning pipes to prevent
ingress of dirt and moisture into the system.
7. Release condenser from lower mountings and
7. Release condenser from lower mountings and
remove condenser.
Refit
1. Clean air conditioning pipe connections.
1. Clean air conditioning pipe connections.
2. Lubricate new 'O' rings with refrigerant oil and fit to
2. Lubricate new 'O' rings with refrigerant oil and fit to
air conditioning pipes.
3. Remove caps from new condenser and fit to old
3. Remove caps from new condenser and fit to old
condenser.
4. Position condenser to lower mountings.
4. Position condenser to lower mountings.
5. Fit mounting brackets to condenser.
5. Fit mounting brackets to condenser.
6. Align mounting brackets to striker plate panel and
6. Align mounting brackets to striker plate panel and
tighten bolts to 17 Nm.

Publicidad

Tabla de contenido
loading

Tabla de contenido