Tabla de contenido
Publicidad
LAMP ASSEMBLY - FOG/DRIVING
$% 86.40.96
Remove
1. Raise front of vehicle.
1. Raise front of vehicle.
WARNING: Do not work on or under a vehicle
supported only by a jack. Always support the vehicle on
safety stands.
2. Disconnect fog/driving lamp multiplug.
2. Disconnect fog/driving lamp multiplug.
3. Remove 3 screws securing fog/driving lamp to
3. Remove 3 screws securing fog/driving lamp to
bumper valance.
4. Remove fog/driving lamp from bumper valance.
4. Remove fog/driving lamp from bumper valance.
Refit
1. Position fog/driving lamp to bumper valance, fit and
1. Position fog/driving lamp to bumper valance, fit and
tighten screws.
2. Connect fog/driving lamp multiplug.
2. Connect fog/driving lamp multiplug.
3. Remove stands and lower vehicle.
3. Remove stands and lower vehicle.
4. Check operation and alignment of fog lamp.
4. Check operation and alignment of fog lamp.
ELECTRICAL
LAMP ASSEMBLY - CENTRE HIGH MOUNTED
STOP (CHMSL)
$% 86.41.32
Remove
1. Apply protective tape to the area around CHMSL.
1. Apply protective tape to the area around CHMSL.
2. Open boot lid.
2. Open boot lid.
3. Disconnect CHMSL multiplug and release harness
3. Disconnect CHMSL multiplug and release harness
grommet.
4. Using a thin round edged flat blade bent to 20° at the
4. Using a thin round edged flat blade bent to 20° at the
tip, apply pressure to one side of the CHMSL and release from
retaining clip.
5. Slide CHMSL from remaining retaining clip.
5. Slide CHMSL from remaining retaining clip.
6. Withdraw harness and CHMSL from boot lid.
6. Withdraw harness and CHMSL from boot lid.
7. Remove CHMSL retaining clips from boot lid.
7. Remove CHMSL retaining clips from boot lid.
Refit
1. Fit retaining clips to CHMSL.
1. Fit retaining clips to CHMSL.
2. Position CHMSL and feed harness through boot lid.
2. Position CHMSL and feed harness through boot lid.
3. Secure CHMSL retaining clips to boot lid.
3. Secure CHMSL retaining clips to boot lid.
4. Connect CHMSL multiplug and secure harness
4. Connect CHMSL multiplug and secure harness
grommet.
5. Remove protection from boot lid, clean and inspect
5. Remove protection from boot lid, clean and inspect
paintwork.
86-9
REPAIRS
Publicidad
Tabla de contenido
