Safety Note; Sun Visor - Schubert S2 SPORT Manual

C. THE HELMET
Note:
Never press the locking pins out with your fingers as they may break.
Caution:
As a result of the double shield lens structure, there is a possibility
of greater light reflection in the face shield, especially when riding at
night. As a rule, such light reflection is regarded as uncritical due to
the absence of misting with this type of visor. However, if this light
reflection should cause you difficulties - because of particular sensitivity
to it, for example – you should refrain from using the anti-fog lens.
Caution:
If moisture is present in or has penetrated the airtight area between the
two plates, you should remove the anti-fog lens immediately in order to
prevent any interference with visibility. Do not re-fit it until both plates
are completely dry (we recommend air-drying). If, after this, it is clear
that moisture is still getting in, please take the anti-fog lens to your
retailer for inspection.

SAFETY NOTE

Check before each journey that the face shield and suns visor mechanism
are functioning correctly and that the face shield and sun visor will provide
good visibility. Any dirt should be removed before setting off. Check the face
shield and sun visor for physical damage and cracks. Severely scratched or
matt face shields will seriously impair visibility and should be replaced before
setting off on a journey.
Caution:
Petrol, solvent and fuel vapours can cause cracking of the face shield.
Make sure that the face shield is never exposed to such vapours! Never
place the helmet on the tank of your bike.
62

11. SUN VISOR

SUN VISOR
The sun visor is tinted grey and has a 3D shape. Thanks to the sun visor's
1.5 mm thickness, it provides protection against small stone chips or insects
when driving with the visor up. It is also scratch-resistant and offers effective
UV protection* with its special polycarbonate structure.
* Tested in accordance with the Australian sunglasses standard AS/NZS 1067:2003 lens category 3.
OPERATION
The sun visor is operated by means of the slide
positioned on the left in the chin area, which is easy
to use even when wearing gloves.
Moving the slide towards the back lowers the sun
visor, moving it forwards retracts the sun visor inside
the inner helmet shell and locks it in position.
The sun visor can be operated irrespective of the
position of the face shield.
Note:
Only use the slide to operate the sun visor.
Caution:
Never ride in the dark or in conditions of poor visibility with the sun
visor down. Always raise the sun visor before entering a tunnel.
Caution:
Riding without the face shield or with an open face shield can result
in injury to the eyes and face from stones, dust, insects and other
flying objects. The sun visor, when lowered, will offer a certain amount
of protection from light impact from stones or insects but does not
provide protection against all hazards.
EN
63