Schubert S2 SPORT Manual página 36

C. THE HELMET
3. Push the chinstrap and chinstrap
pad through the opening in the high-
comfort cheek pad.
4. Now pull the loop of the neckband over
the chinstrap and pull the neckband
tight from the back.
5. Push the plastic tongue with round
holes on the head pad over the pin
sewn in to the back of the cheek pad
and fix it in place using the red plug-in
strip.
6. Fix the remaining two pins on the
cheek pad into the red plug-in strips.
68
7. Repeat steps 2–6 for the second cheek
pad.
8. Replace the acoustic collar in the guide
strip between the bottom edge of the
helmet and the high-comfort cheek
pads. Start inserting it at the back and
slowly feed the acoustic collar along
the guide strip.
Note:
Ensure that the neckbands are not
twisted.
Removing the headband pad
1. First remove the high-comfort cheek
pads.
2. The headband pad is attached to the
inner shell by means of Velcro strips
and clamps and can be removed by
pulling it out carefully.
Fitting the headband pad
The plastic strip sewn into the front section and
the clips in the neck area serve as attachments
for the headband pad.
1. Slide the plastic strip gradually under
the notches of the plastic strip
attached to the inner shell.
EN
69