Care And Maintenance; Outer Shell; Face Shield And Sun Visor - Schubert S2 SPORT Manual

F. FOR YOUR SAFETY
Benzene, solvent and fuel vapour can cause cracks in the face shield.
Keep the face shield away from such vapours and do not allow these
kinds of substances to come into direct contact with the face shield!
Never place the helmet on the tank of your motorcycle.
Make sure the face shield is always in perfect condition.
Don't ride when visibility is poor!
MODIFICATIONS / ACCESSORIES
Original components (in particular on the outer shell, inner shell
and restraint system) should not be altered or removed. The fitting
of additional parts from other manufacturers that have not been
recommended can reduce the protective effect and renders the ECE
certification and all warranty and insurance claims invalid.
Use only original parts, replacement parts and accessories that
SCHUBERTH has expressly approved for your helmet!
80
G. CARE AND MAINTENANCE

1. OUTER SHELL

To clean the helmet shell, you can use water, soap or one of the commonly
available motorcycle shampoos, cleaners, polishes, plastic cleaners or clea-
ning fluids. Using water and soap is usually sufficient. Make sure when using
the other cleaning materials that these do not come into contact with the
face shield, since they can cause damage to the visor and its coating.
Note:
Never use motor fuel, thinners or solvents to clean the helmet.
These substances can cause serious damage to the helmet with no
external signs. The full safety function of the helmet can then no longer
be guaranteed.

2. FACE SHIELD AND SUN VISOR

OUTER SURFACE OF THE FACE SHIELD
Use a soft cloth and a mild soap solution (< 20 °C) to remove dirt from the
outside of the face shield. To dry the face shield, use a lint-free cloth and
apply gentle pressure.
ANTI-FOG LENS
The inside surface of the face shield must only be cleaned with a soft cloth,
which may be slightly dampened if required (we recommend a mocrofibre
cloth). Do not use any cleaning agents.
EN
81